Pella Performance Upgrade And HurricanesHield Impact Res Manual de usuario Pagina 1

Installation Instructions for Typical Wood Frame Construction.These instructions were developed and tested for use with typical wood frame wall constr

EXTERIOR FINISHThe exterior frame and sash are protected by aluminum cladding with our EnduraClad® or EnduraClad Plus baked-on factory finish that need

C. Cut the water resistive barrier (1C). See page 10 for additional cutting patterns. D. Fold the water resistive barrier (1D). Fold side flaps into

A. Install and level shims. Place 1" wide by 1/4" thick shims on the bottom of the opening, 2-1/2" from each side, beneath transition

F. Insert the window from the exterior of the building. Place the bottom of the window on the spacers at the bottom of the opening, then tilt the top

A. Units that do not have pre-applied fin corners: Cut four pieces of flashing tape 1-1/2" long. Apply one piece of flashing tape to each end of th

D. Fold down top flap of water resistive barrier (3D).E. Apply flashing tape to diagonal cuts. Cut pieces of flashing tape at least 1" longer than

4SECURING THE WINDOWA. Install a #10 x 3-1/2" corrosion resistant wood screw into each pre-drilled screw hole.Note: Minimum 1-1/4" embedmen

7SEALING THE WINDOW TO THE EXTERIOR WALL CLADDINGWhen applying siding, brick veneer or other exterior finish material, leave adequate space between the

A. Insert closed cell foam backer rod into the space around the window so there is approximately 3/8" clearance between the backer rod and the e